GPM (Gallons per Minute)
GPM stands for Gallons Per Minute — the volume of water a pressure washer delivers per minute of operation. While PSI gets the headlines, GPM is what actually does the cleaning. Think of it this way: PSI is the hammer's strength; GPM is how many hammers you're swinging. Higher GPM means more water flowing across the surface, which means faster dirt removal, better rinsing of detergents, and shorter job times.
In depth
Consumer electric pressure washers deliver 1.2-1.6 GPM. Professional gas units run 4-8 GPM. Commercial hot-water skids used for parking lots can exceed 10 GPM. GPM also controls how far soap can be projected (soap distance), how well a surface cleaner functions, and how quickly landscaping can be pre-soaked for protection. When combined with PSI, the product of the two numbers yields "cleaning units" — a crude but useful measure of a machine's real-world cleaning speed.
How this shows up on our jobs
Our truck-mounted rigs deliver 5.5-8 GPM of hot water, which means we finish Madison-area driveways and patios in half the time of consumer gear — with better results.
Services where this matters
Related terms
PSI (Pounds per Square Inch)
PSI is the unit of pressure used to rate pressure washers, measuring the force of water exiting the pump per square inch of surface area. Consumer pressure washers run 1,500-2,500 PSI; professional rigs typically produce 3,500-5,000 PSI; and specialty surface cleaners can spike above 8,000 PSI. Higher PSI is not always better — in fact, for most home exterior surfaces, high PSI is destructive. Vinyl siding, wood shingles, soft mortar, roof granules, and painted surfaces all fail under excessive pressure.
Pressure vs. Volume
Pressure (PSI) and volume (GPM) are the two fundamental outputs of a pressure washer, and understanding the tradeoff between them is the single biggest step an amateur can take toward professional-level results. Pressure is the force of water hitting a single point; volume is the amount of water moving across a surface over time. A high-PSI, low-GPM machine cleans a tiny spot aggressively — great for lifting paint, terrible for washing a driveway. A moderate-PSI, high-GPM machine cleans broadly and gently — great for siding, wood, and most large surfaces.
Surface Cleaner
A surface cleaner is a circular attachment — typically 16, 20, or 24 inches in diameter — that replaces the wand on a pressure washer for cleaning flat horizontal surfaces. Inside the housing, two or four high-pressure nozzles spin on a swivel bar, blasting the surface at a consistent angle and distance while a skirt contains the spray. The result: an even, streak-free clean across a driveway, patio, or sidewalk in a fraction of the time a wand would take — and without the wand-streak "zebra stripes" that plague amateurs.
Hot Water Pressure Washing
Hot water pressure washing uses a diesel-fired burner to heat the pressure washer's output to 180-200°F before it hits the surface. The physics is simple: hot water dissolves grease and oil, accelerates chemical reactions, lowers the dwell time needed for detergent to work, and kills biological growth on contact. Cold-water pressure washing relies on mechanical force and chemistry alone, which means longer jobs and lower performance on greasy substrates.